Passing 2-dimensional arrays between subroutines

I cannot seem to get this to work.

I want to pass a 2D-array from a subroutine to other subroutines in which a data manipulation should take place.

I am calling below subroutine from a command button on Sheet1. In Module1 I have declared the variables as public. Inside the subroutine ReadData, at the End If statement, InputArray is populated with an array consisting of numbers that the user has marked following the inputbox. After the subroutine ReadData has completed, InputArray is empty.

What is the obvious and blatantly daft thing that am I doing wrong?

Sheet1:

Please Login or Register  to view this content.

Module1:

Please Login or Register  to view this content.

Your code worked for me without any changes. InputArray was populated after the procedure ended.

I might change this just to avoid ambiguity.

Please Login or Register  to view this content.

edit:- Code tags added to post #1 moderation request removed.

Rule 08: Cross-posting Without Telling Us

Your post does not comply with Rule 8 of our Forum RULES. Do not cross-post your question on multiple forums without telling us about your threads on other forums.

Post a link to any other forums where you have asked the same question. If you have fewer than 10 posts here, you will not be able to post a link, but you must still tell us where else you have asked the question.

Cross-posting is when you post the same question in other forums on the web. The last thing you want to do is waste people's time working on an issue you have already resolved elsewhere. We prefer that you not cross-post at all, but if you do (and it's unlikely to go unnoticed), you MUST provide a link (copy the url from the address bar in your browser) to the cross-post.

Expect cross-posted questions without a link to be closed and a message will be posted by the moderator explaining why. We are here to help so help us to help you!

Read this to understand why we ask you to do this, and then please edit your first post to include links to any and all cross-posts in any other forums (not just this site).

If you have less than 10 posts, do not try to copy and paste the link. Instead, type the link out in your thread.

No further help to be offered, please, until the OP has complied with this request.

@ Pak - do not post-edit your posts, as it renders the thread meaningless and useless to anyone looking for help with a similar issue. Do not do this again.

What you were asked to do is provide cross-post links. We are still waiting for you to provide these. Once you have done so, you may receive further help if you need it.