Application.EnableEvents and Application.ScreenUpdating doubt

Hi,

Could you please give me some advice on how to properly use Application.EnableEvents and Application.ScreenUpdating?
The below dummy macro runs with no problems, but if a error is found I think it's not enabling EnableEvents and ScreenUpdating back, is it?
It will go to Exit sub and therefore ignore the previous code. Is it OK to have the TRUE lines between Exit Sub and End Sub?

Please Login or Register  to view this content.

Thank you for your time!

If you Exit the sub then the events are left turned off... Generally, you should explicitly turn them back on again however you exit the procedure.